I suspect the V2.1 stuff will also work with the older V2. I'd start by using the ST-LINK Utilities, make sure you update the firmware, and then use the V2 or V2.1 driver package as appropriate, and the 32-bit or 64-bit installer depending on your version of Windows.
How to install jr programmer drivers windows 10 drivers#
The V2.1 drivers are for the mbed enabled version of the ST-LINK. The J-R Programmer uses an updated driver set that is also used by the Xecuter NAND-X but the old drivers do not work so you need to manually delete a few files and re-install with this new driver set (both the NAND-X and J-R Programmer will also work together on the same computer after you have installed the new drivers). And totally forgot to back up my nand-x drivers. Has anyone got a working link to download them as. Go to device manager and right click on the device then update manually. Need help installing Drivers of Jr Programmer V2. KESS V2 Read and Reprogram data Risk: When reading or programming data via KESSv2, if the communication between the tool and the electronic control unit were to be interrupted problems may occur, also of serious entity and which may extend to the complete failure of. Then connect KESS V2 to computer and run kess v2 software,now you can use it. XECUTER JR-PROGRAMMER driver is a windows driver. The software works on Windows XP,Vista,7,8,8.1,10. The software works on Windows XP,Vista,7,8,8.1,10.
The newer version GQ-4x4 has two beep sounds from programmer when it is power on.